308 electric tailgate lift install manual

By HansShoW | 10/20/2020 |

Features:

1. preferable height adjustment
2.speed control
3. abnormal detection & prompt
4. anti-pinch
5. non-destructive installation

Control method:

1. remote car key
2. tailgate button
3. central control button

Purchase link: https://www.hautopart.com/product/peugeot-308-smart-power-tailgate/

How to install it?

1.Original car appearance
2. Remove middle panel.
3. Remove the 2 side panel.
4.Remove the handle box.
5. Remove the big trim.
6. Use a tool to open the gas spring
retaining spring and remove
the gas spring strut.
7. Replace the original under carriage
bracket and fix it with our screw.
8.Replace the original ball head to
our gasket and ball head
9.Install the electric strut (L
means left, R means right)
10. Take out the rubber stopper.
11. Pass through the strut wire to
the hole.
12. Remove the latch trim.
13. Remove original latch.
14. Install our latch with original
screw
15.Fixing the latch motor.
16. Remove the small box near
to steering wheel.
17. Connect the power cord
to a 20A constant electric fuse.
18. Make a 16mm hole to
install front button.
19.Front wire’s wiring diagram
20. Connect the ground wire to the
tailgate GND screw as shown.
21.Remove the tailgate lock plug,
connect our lock plug with it.
22.Find the handle clasp plug in
the handle clasp
23.Connect the red 12V open lock signal
wire to the 12V wire in the handle clasp
plug, use a multimeter can test the 12V
wire.
Connect the black GND wire to the GND
wire in the handle clasp plug.
Connect the front button yellow ACC
wire to other original button 12V wire.
Connect the front button black GND wire
to any GND screw.
24. Connect the related wire to
the controller and fix the controller.
25.Make a hole to install the
tailgate button.
26. Before recover all panel, check all the wire
and connected right. Power on the system.
Please use your hand close the tailgate at the
first time. Then you can use the car key to control
the tailgate.

Installation Precautions

1.All harness ports, control boxes,
poles, etc. can not energized until
they are installed.
2.Pay attention to the direction of
power take-off, must be connected
to 20A constant electric fuse.
3.When installing the wire, it must
be operated with the engine off
and the car key unplugged.
4.If there is a situation where the
tailgate cannot be closed, remove
the rubber plug in the lock head.

Remarks: After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.

How to use the remote control: Press the key unlock button 3s to open or close the tailgate; Cab button: Press to open the tailgate and press it to close the tailgate

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty

Posted in Car tailgate & power running board news

Leave a Comment