A3 2014+ electric tailgate lift install manual

Features

Features
The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions

Easy to open
The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user

Purchase link:https://www.hautopart.com/product/audi-a3-automatic-truck-tailgate-opener/

Disclaimer: Please do not energize the electric strut until the electric strut is installed in the tailgate. The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.

Install step

1.Remove the trunk mat and use a tool to pry out the decorative panel as shown below.
2.Take out the original car latch and install our electric latch.
3.Remove the baffle on the right-side door of the trunk and pry open the trim panel, replace the original car screw with our M5*25 screw.
4.Install the rivet nut in the position shown below
5. Install our bracket as shown.
6.As shown in the figure, install our bracket on the swing arm of the tailgate.
7. Install our electric strut on the bracket.
8.Install the tailgate button here.

Note:Wires not marked in the ma not need to connect.

Motor plug is in tailgate,
Remove the original motor plug connect our motor plug with it
Fuse box under steering wheel trim Connect our power wire to a 20A constant electric fuse.

Remarks: Before recovering all panels, check all the wire and connected right. Power on the system. Please use your hand to close the tailgate for the first time. Then you can use the car key to control the tailgate. Finally, the installation is complete.

Height adjustment:
After the installation is completed, make the decoder connected to the power supply and the tail door needs to be matched: adjust the electric tail door to the highest position, press the tail door button for 5 seconds and release the button after a long beep sound, then the matching operation is completed (if the car battery runs out, the matching operation needs to be re-matched).

The original rear door buttonNew tailgate buttonKey Remote controlDriver front button
OpenClick once/Press and holdPress and hold
Close/Click oncePress and holdPress and hold

Disclaimer: Please do not energize the electric strut until the electric strut is installed in the tailgate. The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.

Leave a Comment