Baojun 530 electric tailgate lift install manual

By HansShoW | 09/08/2020 |

Features

The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control the tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions

Easy to open
The electric tailgate can be controlled by the tailgate switch and the vehicle key.

Intelligent anti-pinch
When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user.

Disclaimer: Please do not energize the electric strut until the electric strut is installed in the tailgate. The problems and losses caused by improper installation and improper use are not covered by our company’s warranty

Product detail


Installation steps

1. Original car appearance
2. Remove middle panel.
3. Remove the 2 side panel.
4. Remove the handle box.
5. Remove the big trim.
6. Use a tool to open the gas spring
retaining spring and remove
the gas spring strut
7. Install the electric strut (L
means left, R means right)
8. Take out the rubber stopper.
9. Pass through the strut wire to
the hole.
10. Remove original handle clasp
plug, connect it with our plug.
11. Remove car original lock plug, connect it
With our lock plug.
12. Remove the latch trim.
13. Remove original latch.
14. Install our latch.
15.Fixing the latch motor.
16. Remove the small box near
to steering wheel.
17. Connect the power cord
to a 20A constant electric fuse.
18. Make a 16mm hole to
install front button.
19.Front wire’s wiring diagram.
20. Connect the ground wire to the
tailgate GND screw as shown.
21. Connect the related wire to
the controller and fix the controller
22.Make a 22mm hole to install the
tailgate button
23. Before recover all panel, check all the wire
and connected right. Power on the system.
Please use your hand close the tailgate at the
first time. Then you can use the car key to control
the tailgate

Installation Precautions

1.All harness ports, control boxes,
poles, etc. can not energized until
they are installed.
2.Pay attention to the direction of
power take-off, must be connected
to 20A constant electric fuse.
3.When installing the wire, it must
be operated with the engine off
and the car key unplugged.
4.If there is a situation where the
tailgate cannot be closed, remove
the rubber plug in the lock head.

Remarks: After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.
How to use the remote control: Press the key to unlock button 3s to open or close the tailgate; Cab button: Press to open the tailgate and press it to close the tailgate.
Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.

Posted in Car tailgate & power running board news

Leave a Comment