Benz A class electric tailgate lift install manual


The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control the tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions

Easy to open: The electric tailgate can be controlled by the tailgate switch and the vehicle key.

Intelligent anti-pinch: When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user.

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty

1. Remove the trim with the
step as shown.
2. Use a screwdriver to remove the
head ball and remove the left and
right poles .
3. After removing the original car
head ball, install our head ball with
4. Install the electric tailgate
5. In the position shown below, drill
a φ20 hole with our driller, make
the pole wire passes through this hole
6. Remove the original lock ring,
install our electric lock ring. The
drawstring of the lock passes
through the hole。
7. Install the tailgate button
as shown.
8. Wiring diagram: Purple line:
button wire; Red line, pole wire;
Yellow line, electric lock wire;

Note: after the installation is completed, please confirm that the ball head is stuck by the clamping ring. Under normal circumstances, pulling back the strut cannot be pulled, and the position of the clamping ring is shown in the figure.

Remarks: After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.

Height adjustment: After the installation is completed, make the decoder connected to the power supply and the tail door needs to be matched: adjust the electric tail door to the highest position, press the tail door button for 5 seconds and release the button after a long beep sound, then the matching operation is completed (if the car battery runs out, the matching operation needs to be re-matched)

Note: the installation instructions may be slightly different from the actual operation. If there is any problem, please operate according to the actual situation or contact us.

Leave a Comment