Benz E Class Power Tailgate Installation Manual

By HansShoW | 11/12/2020 |
1.Remove trunk
trim
According the order remove
trunk trim.
2.Remove trunk
trim
According the order remove
trunk trim.
3.Install rivet nuts
Install M8 rivet nuts on both sides of
the body.
4.Install body bracket
Install the bracket in the location equipped with the
M8 riveting nut, left and right installation is the
5.Remove original
spring
Remove original left and right side spring
6.Remove the original
plastic buckle
Remove the plastic buckles on the left and
right side of the original hanging springs
7.Install right ball head
Install our shorter ball head on the right
side, and the delivery bracket is
attached to the original spring hanger .
8.Install left ball head
Install our longer ball head and
bracket on the left side.
9.Install electric struts
Install our electric left and right
struts on brackets and ball head
10.Install self-priming locking
block
Unscrew the four screws on the back, take off the
bottom cover plate, take off the pull rope, which is
passed through the hole on the right side, and
then restore our company’s self-priming lock block
11.Install self-priming
locking block
If you encounter a deviation between the
original lock and the lock ring, install the
self-priming lock to the left as follows.
12.Install tailgate button
Cut square holes in the locations
shown below to install the button.

一：Height adjustment
Adjust the tailgate to the right height, press and hold the tailgate button for 5 seconds, a long beep means the height is set successfully, when you open it again, it will open to the set height.
二：Speed adjustment
The tailgate switch speed is divided into 5 gears, default 4 gears, minimum 2 gears, maximum 6 gears. Press and hold the tailgate key, when you hear the buzzer sound 2 times in a row, it means the speed setting is 2 speed successfully, when you hear the buzzer sound 3 times in a row, it means the speed setting is 3 speed successfully, and so on.

**After installation, when the decoder is plugged into the power supply, matching operation is needed: adjust the electric tailgate to the highest position, press and hold the tailgate retrofitting button for 5 seconds, release the button after a long beep, then the matching operation will be completed (re-powering requires matching operation again).

Posted in Car tailgate & power running board news

Leave a Comment