BMW Mini three door Electric Tailgate Installation Instructions

1.Before installation, confirm whether the
original door is flat and the gap between
the left and righ of the door is large.
2.Remove the tail inner panel
Remove the tailgate panels as the order
indicated (see the figure below).
3.Remove the original car Strut
Remove the left and right Struts of the
original car (see the arrow below).
4.Install ball head for car body
After removing the original car Strut, remove the
ball head on the original car, and install the ball
head + gasket provided by our company
5.Install Electric Strut
Install the left and right electric struts
supplied by our company on the bracket.
The strut wire passes through the original door hole.
6.Install self Suction lock
7.Install tailgate button
Open the hole ∮20 as shown in the figure
below, and install our tailgate button.
8.Precautions
No need to connect to unlock wire
9.Connect wire diagram
The input power end must connect to the live end of the original car’s normal power fuse. If it is connected reversely, it will cause the original car’s fuse to be over current. Before installation, be sure to use the car electric pen to determine the power input end. The current trend is shown by the schematic

1 Height adjustment
Adjust the tailgate to a suitable height, press and hold the tailgate button for 5 seconds until hear a long beep. It indicates that the height is set successfully, and it will open to the set height when it is opened again.

2 speed adjustment
The tailgate switch speed is divided into 5 gears, the default setting is 4 gears, the lowest 2 gears, and the highest 6 gears. Press and hold the tailgate button. When you hear the buzzer beeps twice, it means that the speed setting is successful; when you hear the buzzer beeps for three times, it means that the speed is set to gear 3 successfully, and other gear are similar.

After installation, the decoder needs to be matched when plugged in: adjust the electric tailgate to the highest position, press and hold the tailgate extra button for 5 seconds, and release the button after a long beep, then the matching operation is complete (restart Need to re-match operation after power-on).

Note: The installation instructions may be smally different from the actual operation. If there is any difference, please operate according to the actual situation or contact us.

Leave a Comment