Compass electric tailgate lift install manual


1.Open and Close the tailgate by using kick sensor,key fob,car front button
2.Height memory, automatic height adjustment warning reminder when tailgate maybe pinch you.
4.low power consumption operation

To get it:

HOW to install it?

1. Remove the trim with the
step as shown.
2. Use a screwdriver to remove the
head ball and remove the left and
right poles .
3. Install the electric tailgate
4. In the position shown below, drill
a φ20 hole with our driller, make
the pole wire passes through this hole
5. Remove the original lock
ring, install our lock ring.
6. Install the tailgate button
as shown.
7. Make a 20mm hole, Install
the front tailgate button
as shown.
8. Fix the controller in the
tailgate as shown
Note: after the installation is
completed, please confirm that
the ball head is stuck by the
clamping ring. Under normal
circumstances, pulling back the
strut cannot be pulled, and the
position of the clamping ring is
shown in the figure.

Disclaimer: The problems and losses caused by improper installation and
improper use are not covered by our company’s warranty.

Remarks: After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.

Height adjustment: After the installation is completed, make the decoder connected to the power supply and the tail door needs to be matched: adjust the electric tail door to the highest position, press the tail door button for 5 seconds and release the button after a long beep sound, then the matching operation is completed (if the car battery runs out, the matching operation needs to be re-matched).

Note: the installation instructions may be slightly different from the actual operation. If there is any problem, please operate according to the actual situation or contact us.

Leave a Comment