E-Pace electric tailgate lift install manual

Features

The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions

Easy to open: The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch:When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user.

Configuration list

Control box
Poles
Tailgate button
Tailgate button wire
Power cable
Tailgate lock control wire
Electric suction lock wire
Cable tie * 20
Make hole indication module
3M glue*2
Longer 3M glue
Hole opener (16 mm)

Precautions

1.Electric tailgate installation precautions For safety and to ensure the normal use of the product, please install it by professional staff.

2.Make sure that there is enough power in the car battery to ensure that the electric tailgate kit works properly. If the battery is low, test the electric tailgate after starting the engine for a while

3.Before the electric pole is installed, the direction and position are determined to avoid damage caused by the reassembly and the circlip is loose. The ball head must be installed in place to prevent the electric pole from falling

4.When arranging CAN lines, power lines, button lines, and control box lines, it is necessary to clearly distinguish the specific connection methods of these lines to prevent misconnection

5.Do not plug or unplug the connected leads while the power is on to avoid damaging the main unit.

Lay wiring diagram

Installation process

1. original car appearance
2. Original car appearance
3.Open the tailgate and remove the trim
4. Remove the airbag poles on
the left and right sides
5. Remove the poles bracket and
install our bracket with our screws.
6. Install the electric poles
as shown (wire in the upper part)
7. Pass the pole wire through
the tailgate from the hole
8. Remove the luggage cover and then
remove the decorative block of lock hook
9. Remove the lock hook
10. Put on the electric lock, if there is a gap
or the tailgate cannot be closed when the kit
working, you can adjust the position of the lock.
11. Unplug the control cable of the
original car lock and connect it with
our lock cable
12. Connect the ground wire of
the control box to the screw in the figure
13. Connect all the wires on the
control box and fix the control
box to the position in the figure.
14. Find the fuse part on the left
or right side of the trunk and
unplug the green 30A fuse in the red circle.
15. Plug the fuse into our power
plug, and plug it into the original socket.
16. Make a hole in the tailgate
and install the tailgate button
17. The tailgate button at the driver
seat also can control the tailgate
on and off.
18. The installation is complete

Tailgate activation learning
Raise the tailgate to the highest position, press down about 2cm manually, long press the newly installed tailgate switch, after hearing the drop, release your hand, then press the tailgate button, the tailgate is automatically closed. The setup is complete. If the door is not closed, you can manually push it gently to close the door.

Height setting
Raise the tailgate to your ideal height, press and hold the newly installed button for about 3 seconds, hear a drop sound, release your hand, press the tailgate button again, and the tailgate closes. The height setting is complete.

Key/button usage
1. The original car remote control key, long press the tailgate button to open the tailgate.
2. Click the tailgate button to open or close the tailgate

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty

Leave a Comment