Fit electric tailgate lift install manual

Features

  1. Open and Close the power tailgate lift using kick sensor.
  2. Open and Close the electric tailgate using the key fob.
  3. Close the power liftgate kit with the supplied button (added in the automatic lift gate).
  4. Open the universal power liftgate kit using front button.

Purchase link:https://www.hautopart.com/product/honda-fit-high-configure-hands-free-power-liftgate/

Electric tailgate functions:

Easy to open:

The electric tailgate can be controlled by the tailgate switch and the vehicle key.

Intelligent anti-pinch:

When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the
user.

Disclaimer: Please do not energize the electric strut until the electric strut is installed in the tailgate. The
problems and losses caused by improper installation and improper use are not covered by our company’s
warranty.

Install guide:

1.Remove the tailgate trim panel .
2.Remove the original strut with screwdriver,
Install our screw as shown.
3.Remove the original left and right strut as shown.
4.Remove the original body bracket and install our
new body bracket, as shown
5.Remove the original tailgate bracket and install
our new tailgate bracket, as shown
6.Install the left and right electric strut.
L means left, R means right.
7.Make a hole in the tailgate and pass through
The strut wire as shown
8.Remove original latch, install our electric latch as shown.
9.Make a hole and install the tailgate lift
button as shown.
10.Wiring diagram:
Red frame: tailgate button.
Light green: controller
Light green: Tailgate button wire
Yellow: strut wire
Red: electric suction motor wire
Fuse box is under the steering wheel trim.
Power cord connects the 20A constant electric
fuse.

GND wire connect the screw
In left tailgate truck trim.

Remarks: Before recover all panel, check all the wire and connected right.
Power on the system. Please use your hand close the tailgate at the first
time. Then you can use the car key to control the tailgate. Finally, the
installation is complete.

Height adjustment:

After the installation is completed, make the decoder connected to the power supply and the tail door needs to
be matched: adjust the electric tail door to the highest position, press the tail door button for 5 seconds and release
the button after a long beep sound, then the matching operation is completed (if the car battery runs out, the matching
operation needs to be re-matched).

Disclaimer: Please do not energize the electric strut until the electric strut is installed in the tailgate.
The problems and losses caused by improper installation and improper use are not covered by our
company’s warranty.

Leave a Comment