Focus 2016 electric tailgate lift install manual


1.easy to insatll,about an hour,no damage to the original car installation
2.A variety of switching methods, free control
3.Smart anti-pinch
4.High memory
5.low noise


Easy to open
The electric tailgate can be controlled by the tailgate switch and the vehicle key

Intelligent anti-pinch
When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user.

purchase link:

Install steps

1.Remove the trim
Remove the left and right handle screw as shown.
2.Remove the trim
Remove the trim follow the steps as shown
3.Install the electric strut
Use screwdriver open the ball hear steel, remove the
Original strut as shown.
4.Install the electric strut
Remove the original strut bracket, install our bracket.
5.Install the ball head
Remove the original ball head, install our ball head.
6.Install the strut
Install our electric tailgate lift as shown.
Note: Make a 22 mm hole, pass the strut wire to the
7.Install electric latch
Remove the original latch, install our electric latch
8.Install the rear button
Make a 20 mm hole, install the rear button.
9.Wiring diagram: Yellow line:
button wire; Red line, pole wire;
Green line, electric lock wire;
10.No need to connect light wire and
yellow unlock-H wire. The shape of
wire as shown.
Note: after the installation is completed,
please confirm that the ball head is stuck
by the clamping ring. Under normal
circumstances, pulling back the strut
cannot be pulled, and the position of the
clamping ring is shown in the figure.

height adjustment
Adjust the tailgate to the appropriate height, press and hold the tailgate button for 5 seconds, and hear a long beep that
indicates the height setting is successful.

speed adjustment
The tailgate switch speed is divided into 5 gears, the default is 4 gears, the lowest 2 gears, and the highest 6 gears. Press and
hold the tailgate button. When the buzzer sounds 2 consecutive sounds, it means that the speed setting 2 is successful. When
the buzzer is heard for 3 consecutive sounds, the speed setting 3 is successful, and so on.

Note:After the installation is completed, the decoder needs to be matched when the power is plugged in: the electric tailgate is adjusted to the highest position, and the tail
button is pressed for 5 seconds. After a long beep, the button is released, indicating that the matching operation is completed. (If the power off requires a rematch operation).

Electric tailgate strength adjustment method

Press and hold for 3 seconds, then press for another second to increase the strength
of the electric tailgate(a total of 5 intensity adjustment)

Tailgate strength adjustment:
Adjustment When the door cannot be opened or the door cannot be closed:Adjust position: The small black button
of the control box (decoder).

Tuning method:
First, the door can not be opened (the door opening is not good )
Press and hold the small black point switch on the control box to adjust the strength of the opening tailgate .
Clicking the black dot 3 seconds, Then, Press and hold the switch, the buzzer will beep 1 to 5 times, 1 sound is the smallest strength, 5 sound is the strongest, and the factory default is 1 sound;
Second, the door can not be closed (the door closing strength is not good)
First, use a screwdriver turn the tailgate lock to close status. (equivalent to closing the door, you must make the tailgate lock in lock status when adjusting the closing force), and then press and hold the small black point switch on the control box to adjust the closing strength. The strength, long press the switch buzzer will ring from 1 to 5 times, 1 sound is the smallest, 5 sound is the strongest, the factory default 1 sound, generally adjusted to 3 sounds, test the closing strength, if still feel not good, try other strength;

Leave a Comment