Ford Everest electric tailgate lift install manual

Features

The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions
Easy to open The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user. Disclaimer: Please do not energize the electric strut until the electric strut is installed in the tailgate. The problems and losses caused by improper installation and improper use are not covered by our company’s warranty

1. Original car appearance
2. Remove trims
3. Remove the both side trims
4.Remove the handle clasp cover
5. Remove the 2 screws
6. Remove the whole panel.
7. Use tools to pry open the snap
rings at the ends of the strut and
remove the left and right strut
8. Remove the original car bracket.
9.Install our bracket. L means left,
R means right., pay attention to the
direction of the left and right brackets
10. Install our power strut. L
means left, R means right
11. Remove original rubber stopper.
12. Insert our strut wire into the hole
and plug it with our rubber stopper
13. Remove original tailgate lock
plug, connect it our lock plug.
14. Remove original handle clasp
plug, connect it with our plug
15. Remove original latch panel.
16. Remove original latch.
17.Install our power suction latch.
18.Fix latch motor on the right
side truck.
19. Connect the ground wire to the
right truck screw as shown
20. Remove this panel on the cab.
Find the fuse box.
21. Connect our power cord to a
20A constant electric fuse.
22. Use driller make a hole here,
install the front button.
23. Route the front button wire and
power cord wire as shown.
24. Routing the harness that connects the
controller as shown in the figure and
passes it through the bellows.
25.Connect related wire to controller,
fixing the control box.
26.Use a 22mm driller make a hole here,
install our tailgate button.
27. After checking all the harness connections,
power on, and close the tailgate once by hand to
complete the system initialization. Check the button
and car key function, make sure no problem, then
recover the panel

Installation Precautions

1.All harness ports, control boxes,
poles, etc. can not energized until
they are installed.
2.Pay attention to the direction of
power take-off, must be connected
to 20A constant electric fuse.
3.When installing the wire, it must
be operated with the engine off
and the car key unplugged.
4.If there is a situation where the
tailgate cannot be closed, remove
the rubber plug in the lock head.

Remarks: After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.

How to use the remote control: Press and hold the car key unlock button(or tailgate button 3 times) to open or close the trunk; Cab button: Press to open the tailgate and press it to close the tailgate.

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty

Leave a Comment