Fortuner electric tailgate lift install manual

Features

Electric tailgate lift assisting system opens and closes your tailgate by simply pressing a button.

This smart aftermarket lift gate provides additional security and value to your vehicle.

Electric tailgate functions

1.A variety of switching methods
2.Height free adjustment memory lock
3.Intelligent electric suction
Read more click here

Product parts detail display

Install steps

1.Original car appearance
2. Remove trims
3.Remove the both side air spring strut
4. Install our power strut.
5.Make a hole in the rubber stopper
6.Make the bellows pass through the hole
7.Pull out the original tailgate handle clasp plug and connect it with our handle clasp plug
8.Pull out the original tailgate lock plug and connect it with our lock plug
9.Remove the original car lock, install our latch, and fix the motor under the left cover
10.Remove the useless button on the left side of the steering wheel in the figure
11.Install our front button
12.In the lower left corner of the driver’s seat, find the plug in the picture, connect our yellow wire to the white signal of the remote control signal wire in the plug (test it with the electric pen, pen’s one end connect the car to the ground, another end connect the white wire, press the car key unlock button, the electric pen will flash once )
13.Open the fuse box, connect our Power cord to a 20A constant electric fuse.
14.Remove the steering wheel trim and find the plug in the steering wheel as shown, connect our related plug to with the plug.
15.Route the harness that connects
the control box along the inside of
the left driver’s lower cover to the tailgate.
16.Route the harness that connects the control box along the inside of the left back row seat lower cover to the tailgate.
17.Pass the control box wire into
the bellows with a tool
18.Fix the wire with a cable tie
19.Connect the ground wire to the
tailgate screw as shown
20.Connect the related plug to
control box, fixing the control box.
21.Use driller make a hole,
install the tailgate button
22.After checking all the harness connections,
power on, and close the tailgate once by hand to complete the system initialization. Check the button and car key function, make
sure no problem, then recover the panel.

Installation Precautions

1.All harness ports, control boxes, poles, etc. can not energized until they are installed.
2.Pay attention to the direction of power take-off, must be connected to 20A constant electric fuse.
3.When installing the wire, it must be operated with the engine off and the car key unplugged.
4.If there is a situation where the tailgate cannot be closed, remove the rubber plug in the lock head.

Leave a Comment