Tucson electric tailgate lift install manual

Features

It can be controlled by:
remote car key
tailgate button
central control button

The add on will amaze friends and make the investment worth a buy. It has:
preferable height adjustment
speed control
abnormal detection & prompt
anti-pinch
non-destructive installation

Purchase link:https://www.hautopart.com/product/hyundai-tucson-electric-tailgate-2016/

Install steps:

1.Original car appearance
2.Remove the trim
3.Remove the screws
4.Remove left and right trim
5.Remove the 2 side screw with tool.
6.Remove the tailgate handle.
7.Remove this big trim
8.Remove the two side struts.
9.Remove the 2 side original bracket,
Install our brackets.
10.Route the strut wire through the hole as shown
11.Remove original lock plug,
Install our lock plug.
12.Connect our white wire to the green
button signal wire of this plug.
13.Install our latch.
14.Fixing the latch motor as shown.
13.Remove original tailgate lock plug, Connect the plug with our lock plug.
16.Connect the ground wire
with the screw as shown.
17.Connect related wire with
Controller, fixing it as shown.
18.Route the wires as shown.
19.Route the wires through the tube.
20.Route the power cord and front button wire from cab to tailgate as shown.
21.Route the power cord and front button wire from cab to tailgate as shown.
22.Remove the panel.
23.Connect the power cord to a 20A Constant electric fuse in the fuse box.
24.Connect the CAN connector 1 to the related terminal. Connect our CAN Plug to Car CAN terminal.
25.Connect our OBD plug to the Original OBD plug.
26.Make a hole here, install the front button.
27.Make a hole here, install
the tailgate button.
28.After checking all the harness connections, power on, and close the tailgate once by hand to complete the system initialization. Check the button and car key function, make sure no problem, then recover the panel.

Installation Precautions

1.All harness ports, control boxes, poles, etc. can not energized until they are installed.
2.Pay attention to the direction of power take-off, must be connected to 20A constant electric fuse.
3.When installing the wire, it must be operated with the engine off and the car key unplugged.
4.If there is a situation where the tailgate cannot be closed, remove the rubber plug in the lock head.

Remarks: After installing the electric tailgate lift, you must manually close it
once and then open it. Finally, the installation is complete.
How to use the remote control:
Press the key unlock button 3 times within 4s to open or close the tailgate;
Cab button: Press to open the tailgate and press it to close the tailgate.
Disclaimer: The problems and losses caused by improper installation and
improper use are not covered by our company’s warranty.

Leave a Comment