Jazz power tailgate installation manul

By HansShoW | 01/23/2021 |

Part one: Step by step installation manual.

1:Remove the tailgate panel.

2:Remove the original struts
Learn how to remove the strut:https://youtu.be/vDdwEi6hSxw
3:Replace the original car tailgate bracket(Please note, there are car tailgate door bracket and car body bracket for tailgate, and the bracket ball head should the same toward as original bracket head)
4:Repalce the car body bracket.
5:Install the right side struts the struts wire need pass though the tailgate light.
6:How to route the struts wire
Remove the tailgate light, Struts wire go though the arrow side
7:Install the suction lock
Remove the original lock ring, and install our suction motor, please noted that need install two gasket for two screw.
8：Remove the original lock Cushion rubber.
9:Install tailgate button
10:Install the Front tailgate button
11:wire routing diagram

Part two: Car circuit diagram.

1: Jazz plug 1 and jazz plug 1, only need connect one wire.

Part three: System adjust.

Height adjustment: 
Adjust the tailgate to the appropriate height, press and hold the tailgate button for 5 seconds, and hear a long beep that indicates the height setting is successful.
Speed adjustment:
The tailgate switch speed is divided into 5 gears, the default is 4 gears, the lowest 2 gears, and the highest 6 gears. Press and hold the tailgate button. When the buzzer sounds 2 consecutive sounds, it means that the speed setting 2 is successful. When the buzzer is heard for 3 consecutive sounds, the speed setting 3 is successful, and so on.

Jazz power tailgate supplier

Posted in Car tailgate & power running board news

Leave a Comment