Land cruiser electric tailgate lift install manual

Features

The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions

Easy to open
The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user.

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty

Install step

1.Remove the middle trim by
using plastic trim tools.
2. Remove the LED light from the
middle trim.
3. Remove the trim panels
on the left and right sides.
4. Removing the big trim.
5. Use the tool to remove the two
side original car air pole.
6. Remove the original pole
brackets on the left and right
sides and install our brackets with
the original screws.
7. Remove the original car brackets
on the left and right sides and install
our brackets with the original screwsA
8. Install the two side electric poles.
9. Cut off a part of waterproof rubber
stopper and make a hole.
10. Put our pole wire into the hole and
plug the rubber plug in the original place.
Do the same step in left and right.
11. Pull out the original car lock plug
and connect with our harness.
12. Use the tool to remove the
original tailgate button.
14. Connect the negative pole of the
power supply to the purple wire shown in the figure.
15. Take out the original car
empty button
16. Install our front button in
the button hole.
17. Connect the power supply wire to a
20A constant electric fuse in the fuse box.
18.Wiring the harness that needs to be
connected to the control box from the cab
side trim cover to the tailgate.
19. Wiring the harness that needs to be
connected to the control box from the
cab side trim cover to the tailgate.
20. Connect our yellow control wire
to the white pink wire in the B-pillar
21. Route the wire that needs to be
connected to the control box from
the trim cover under to the tailgate.
22. Restore all the trim board, manually close the electric
tailgate and initialize the system. Complete installation

Remarks:
After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.
How to use the remote control: Press the key unlock button 3 times within 4s to open or close the tailgate; Cab button: Press to open the tailgate and press it to close the tailgate.

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.

Leave a Comment