1.Remove the tail inner panel Remove inner panle the tailgate as shown in the figure below
2.Remove the original car torsion spring Disassemble the original car torsion spring from the top buckle of the tailgate first, and then remove it from the door swing arm.
3.Install brackets Place the spring hook to the top, and the arc shaped bracket with a hole is attached to the edge of the hook shaft, then mark the hole position in the middle of the swing arm, and then drill the ɸ5 positioning hole.
4.Install brackets Expand the ɸ5 positioning hole on the swing arm to ɸ8.5 (the figure shows the installation on the right, and the installation on the left is the same).
5.Install brackets Firstly, swing the spring hook to the inside and fasten it with a cable tie. Then put on the corresponding hole of the swing arm trim panel, open the ɸ20 hole on the trim panel to pass through the mounting ball head, and open the ɸ5 hole on the edge for fishing cable tie.
6.Install brackets The longer ball head+gasket goes through the hole, and the back is locked with Screw (see the picture below).
7.Precautions Note: The inner edge of the trim panel should be tied to the swing arm with a cable tie to prevent Strut from touching the trim panel when closing the door
8.Install brackets The bracket of the car body opening hole is close to the edge of metal plate convex point, and the opening hole position is pre-opened with a positioning hole ɸ5.
9. Install brackets The bracket of the car body opening hole is close to the edge of metal plate, and the opening hole position is pre-opened with a positioning hole ɸ5.
10.Install brackets Expand the positioning hole to ɸ8.5, insert the toothed bracket to the inside of the metal plate, and install the shorter ball head with a gasket
11.Install electric struts Install the electric strut supplied by our company on the bracket
12.Precautions The installation method on the left is the same as that on the right. The wire box on the left is not used, and the wire box is removed on the left.
13.Install electric lock Remove the original car lock hook and replace our electirc suction lock
14.Install the tailgate button The bracket of the car body opening hole is close to the edge of metal plate, and the opening hole position is pre-opened with a positioning hole ɸ5.
15.Front button of driver room The original tailgate button in driver room opens or closes the tailgate as shown in the following figure.
16.Fishing wire diagram
After installation, the decoder needs to be matched when plugged in: adjust the electric tailgate to the highest position, press and hold the tailgate extra button for 5 seconds, and release the button after a long beep, then the matching operation is complete. (if restart, we need to re-match operation after power-on).