Nissan Murano Power Tailgate install manual

Installation Guide

1.Nissan Car Looks
2.Remove the middle pane
3.Remove Tailgate big panel
4.Remove the left and right screws ,also remove the panel
5.The pictures after removal
6.Pry the spring snap ring from original car,and remove the
strut(The same way for the left and right)
7.Remove the bracket of original car ( The same way for the left and right)
8.Remove the upper bracket of original car ( The same way for the left and right)
9.Install the bracket equipped from our company,use the car screws( “L” is for left, “R”is for right)
10.Install the upper bracket equipped from our company,use the car
screws( “L” is for left, “R”is for right)
11.Install our electric automatic strut ( “L” is for left, “R”is for right)
12.Use our No.13 drill in the position as shown in arrow,the strut wire
passes through from it to connect to control box(The same way for the
left and right)
13.Pull out the button plug of the car,make matched connection with
our converted wire equipped in our company
14.Pull out the lock plug of the car,make matched connection with our
converted wire equipped in our company
15.Pry the left panel
16.Remove the screws by tool
17.Pry the panel as the position
18.Find the remark over 20A to get electricity from fuse box
19.Make matched connection with original OBD
20.Drill it in correct position(16mm for the drill),press the button
before installation
21.The wire harness connected with control box wires along the seat
panel from the inside to the back
22.The wire harness connected with control box wires along the seat panel from the inside to the tailgate
23 The wire harness connected with control box wires along the sealing
strip to the top of the car
24 Pass through the wire tools by the wire tube
25.Remove the tailgate buckle panel,also remove the lock buckle
26.Install our lower suction lock buckle equipped by our company
27 Fix up our lock buckle motor
28 Make matched connection for the wire harness connector and
control box,and also fix up the control box
29 Drill in the right side of tailgate panel,and install tailgate
30 Recover all panels,installation process is finished and recover
again(close manually) so that the system will return to the original state.

product link:https://www.hautopart.com/product/nissan-murano-power-tailgate/

Leave a Comment