Outlander electric tailgate lift install manual

By HansShoW | 12/14/2020 |

Features

The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions
Easy to open ：The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch ：When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user.

Disclaimer: Please do not energize the electric strut until the electric strut is installed in the tailgate. The problems and losses caused by improper installation and improper use are not covered by our company’s warranty

Purchase link：https://www.hautopart.com/product/mitsubishi-outlander-2014-power-tailgate/

Product List

1. Original car appearance
2. Remove the middle panel.
3. Remove the 3 trims.
4. Only remove the car body
bracket screw in this red circle.
5. Use original car body bracket, but
need to change this screw in red circle
to our screw. To prevent electric strut
damage when close.
6. Use screwdriver the remove the 2 original Strut
7. Remove original tailgate ball
head, install our new tailgate ball Head.
8.Install our right strut.
R means right in the strut.
9. Install our left strut.
L means left in the strut.
10. Remove the original lock ring
and the reinforcement behind,
install our electric lock ring.
11.Install our electric latch.
12. Fixing the latch motor here.
13. Use our drill make a hole here
to pass the left strut wires.
14. Use our drill make a hole here to
pass the right strut wires.
15.Left and right strut wire’s wiring
diagram.
16. Power cord wiring diagram.
17. Remove the trim under
the steering wheel.
18. Connect the red power cord to a 20A constant power fuse
as shown. Connect the GND wire to the right screw as shown.
19. Find the plug in the right cab B pillar area.
20.Connect our yellow car key signal wire to the
white with black wire as shown.
21. Remove the useless empty button,
replace it with our front button.
22. Remove original lock plug,
connect it with our lock plug.
23. Find the handle clasp plug, connect our purple
wire with the red wire as shown.
24. Make a hole in the tailgate to install
the tailgate button.
25. Front wire’s wiring diagram.
26.Controller wires routing diagram is as shown.
27. Fixing the controller here.
Before recover all panel, check all the
wire and connected right. Power on the
system.Please use your hand close the tailgate
at the first time. Then you can use the
car key to control the tailgate.

Installation Precautions

1.All harness ports, control boxes,
poles, etc. can not energized until
they are installed.
2.Pay attention to the direction of
power take-off, must be connected
to 20A constant electric fuse.
3.When installing the wire, it must
be operated with the engine off
and the car key unplugged.

Remarks: After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.
How to use the remote control: Press the key unlock button 3s to open or close the tailgate; Cab button: Press to open the tailgate and press it to close the tailgate

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.


Posted in Car tailgate & power running board news

Leave a Comment