Skip to content

Q50 electric tailgate lift install manual

The Q50 electric tailgate lift can bring you the following convenience

  • customized opening and closing speed
  • height adjustable
  • memory system remembers the height of the electric tailgate
  • closing force can also be customized
  • a built-in anti-pinch function
  • sound prompt function

Features
The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control tailgate with the car key tailgate button. It is easy to control and practical.


Electric tailgate functions
Easy to open
The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch
When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the
user.

Disclaimer: Please do not energize the electric strut until the electric strut is installed in the tailgate. The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.

Install steps

Q50 electric tailgate lift install manual
1.Use a screwdriver to remove the original
strut, install our electric strut.
Q50 electric tailgate lift install manual
2.Remove the rear LED light, The strut wire is threaded into the car from the lamp wire tube, and the strut wire is bent into the car according to the schematic diagram to prevent rainwater from flowing into the car along the wire.
Q50 electric tailgate lift install manual
3.The strut wire inlet and outlet should be fastened with
tape.
Q50 electric tailgate lift install manual
4.Because the Q50 latch structure is special, you need to dismantle the latch and then recover the latch, process as shown.
Unscrew the four screws on the back of the latch, remove the bottom cover, take the pull-down cord, pass through the rope to the body sheet metal, and restore our latch.
Q50 electric tailgate lift install manual
5.Remove original latch, install our electric latch.
Q50 electric tailgate lift install manual
6.Use the drill make a hole here, install the tailgate button.
Q50 electric tailgate lift install manual
7.Remove the original anti-collision rubber
from the tailgate and install our anti-collision rubber.
Q50 electric tailgate lift install manual
8.Wiring diagram:
The purple wire is tailgate button wire; Red wire is strut
wires.
The red wire is strut wire.
The light green is electric latch motor wire.
The yellow wire is front power wire.
Put the controller in the purple frame area.
Q50 electric tailgate lift install manual
9.Paste our transparent paint protection film on the position shown(Both left and right).
Q50 electric tailgate lift install manual
Q50 electric tailgate lift install manual
Q50 electric tailgate lift install manual
Find the tailgate lock plug in the tailgate.
Remove original lock plug, connect it with our lock plug

Remarks: Before recover all panel, check all the wire and connected right. Power on the system. Please use your hand close the tailgate at the first time. Then you can use the car key to control the tailgate. Finally, the installation is complete.

Height adjustment:
After the installation is completed, make the decoder connected to the power supply and the tail door needs to be matched: adjust the electric tail door to the highest position, press the tail door button for 5 seconds and release the button after a long beep sound, then the matching operation is completed (if the car battery runs out, the matching operation needs to be re-matched).

Q50 electric tailgate lift install manual

Disclaimer: Please do not energize the electric strut until the electric strut is installed in the tailgate. The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.

Purchase link:https://www.hautopart.com/product/infiniti-2013-q50-power-tailgate/

Leave a Comment





Scroll To Top
WhatsApp Click here to whatsapp us