Skoda KAROQ electric tailgate lift install manual

By HansShoW | 01/19/2021 |

Features

The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions

Easy to open
The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch
When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user

special attention

If the poles are removed several times, the two sides of poles
should be replaced with our spare pole clip spring (if you do not
pay attention to this matter, and not operate the poles as
required, There is a danger of loose the pole. Please be careful.)
2: Please note that after the installation is complete, you can
shake the left and right poles. To check if the poles are installed well.
3: Please note that after the installation is completed, the
tailgate lock cannot be locked to the lock ring. You can
remove the rubber pad pointed by the original car lock as
shown in the figure. That will solve this problem.

Installation steps

1. Original car appearance
2: Remove the original car trim as shown
3: Remove the left and right poles of the original car as
shown in the figure (there must be someone to
support the door when disassembling)
4.Install the left and right poles of our
company with the original car bracket
as shown in the figure (there must
be someone to support the door when installing)
5: As shown in the figure, punch the
hole in the frame selected in the figure.
Our pole Hall line can be penetrated
from the punched position (the left and
right are the same)
6: our pole Hall wire, wiring
as shown in the figure.
7: Power supply and central control wire diagram as shown
in the figure (red for power supply, green for central control)
8: Motor Hall wire wiring diagram as shown
9: Install the electric fuse wire
under the cab as shown in the
figure. (The fuse power must be
constant 20A electricity .)
10: As shown in the cab belt position,
the original car brown yellow control
wire is connected with our green
control wire.
11: connect ground wire in the tailgate
as shown in the figure. The ground wire
needs to be connected to screw or iron,
Must be able to conduct electricity
12: Insert our lock control wire and
the original car lock control wire as
shown in the figure.
13: Remove the original car lock frame and trim panel as shown in
the figure, install our lock ring.
14: Stick the 3M adhesive on the back
of the motor as shown in the figure.
15: Install the motor under the lock ring as
shown in the figure and fix it with tape.
16: Insert the Hall wire, power cord,
And electric suction lock plug according
to the colour as shown in the figure.
17: Fix the central control box to the tailgate with 3M glue as shown
18: As shown in the figure, install the
door button at the finger position.

Posted in Car tailgate & power running board news

Leave a Comment