Terra electric tailgate lift install manual

By HansShoW | 10/29/2020 |

Features

1.Open and Close the power tailgate lift using kick sensor.
2.Open and Close the electric tailgate using the key fob.
3.Close the power liftgate kit with the supplied button (added in the automatic liftgate).
4.Open the universal power liftgate kit using front button

Electric tailgate functions

Easy to open
The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch
When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user.

Where to buy it: https://www.hautopart.com/product/nissan-terra-2017power-tailgate/

Install manual

1. Original car appearance
2. Remove the panel clip.
3. Remove handle box
4. Remove the big trim.
5. Remove the original strut.
6. Remove the original bracket.
7. Install our new bracket.
(L mean left, R mean right)
8.Install our power strut.
(L mean left, R mean right)
9.Use 16mm drill make a hole here.
10.Pass the strut wire here
11.Un plug the original lock plug connect
It to our lock plug.
12.Un plug the original handle button plug,
connect it to our handle button plug.
13.Connect the GND wire in
GND screw here.
14.Remove the trunk trim.
15.Remove the original latch.
16.Install our electric latch.
17.Fix the latch motor here.
18.Remove the co-driver box panel.
19.Connect the power wire to a
20A constant electric power fuse.
20.Remove the original OBD plug.
21.Connect our OBD plug with it.
22.Connect our OBD plug with OBD plug.
23.Make a 16mm hole here to install the front
Button.
24.Wire the power wire as shown.
25.Front wiring diagram
26.Pass through the controller wire
to the tube as shown.
27.Connect the plug to the controller
fixing the controller here.
28.Make a 22mm hole here to install the
tailgate button.
29.Before recover all panel, check all the wire
and connected right. Power on the system.
Please use your hand close the tailgate at the
first time. Then you can use the car key to control
the tailgate.

Installation Precautions

1.All harness ports, control boxes,
poles, etc. can not energized until
they are installed.
2.Pay attention to the direction of
power take-off, must be connected
to 20A constant electric fuse.
3.When installing the wire, it must
be operated with the engine off
and the car key unplugged.
4.If there is a situation where the
tailgate cannot be closed, remove
the rubber plug in the lock head

Note：

Remarks: After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.
How to use the remote control:
Press the key unlock button 3s to open or close the tailgate;
Cab button: Press to open the tailgate and press it to close the tailgate.

Disclaimer: The problems and losses caused by improper installation and
improper use are not covered by our company’s warranty.

Posted in Car tailgate & power running board news

Leave a Comment