Tourneo electric tailgate lift install manual

By HansShoW | 12/18/2020 |

Features

The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions

Easy to open
The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user.

Install guide

1. Remove the tailgate trim
Remove the trim and left, right LED light
with the order of the number as shown.
2. Make a hole for left and right ball head
Make a hole for left and right by use our Use our hole open template module to
check the central of the hole.Then make the hole as shown. This part is very important, please must be careful.(See the arrow below, the left and the right hole in the same way)
3. Make a hole for left and ball head
Use our long driller make hole in the central position as shown.
4. Install the ball head
Install our new ball head, remember to use our gasket
5. Obliquely cut the left and right brackets
Use the angle grinder to cut the left and right
brackets like the picture. Only in this way can we install our electric struts
6. Obliquely cut the left and right brackets
Install our left and right power strut as shown
7. Install the bracket
Change the original bracket to our new bracket.
8. Install the electric strut
Change the original strut to our new power strut
9. Strut wiring diagram
Make a 20 mm hole as shown in the position,
Used for pass through strut wire.
10. Install the electric suction lock
Remove the original latch base buffer rubber
and install it to our new latch.
9. Install the electric suction lock
Fix our lock as shown in the figure, draw the
central point of the above two holes, remove
our lock base, make 2 10mm holes in the
original car sheet metal, be careful not to touch the M8 screw.
10. Install the electric suction lock
Use M8 screw Install our new electric suction latch on as shown
11. Install the electric suction lock
Remove the pillar in the middle of the tailgate latch as shown.
12.Fix the electric suction motor
Put the electric suction motor in this place as shown.
13.Install the tailgate button
Make a 20mm hole and install the tailgate button as shown
14.Install the front button
Install the front button in this place as shown.
15.Wiring diagram

Posted in Car tailgate & power running board news

Leave a Comment