Volkswagen T-Cross Electric Tailgate Installation Guide

1.Remove trunk trims
Remove the trunk interior trim panel (pictured) in
the order indicated
2.Remove original struts
Use a flat-blade screwdriver to pry open the ball
retainer clips and remove the original left and
right struts. (see the arrow below ).
3.Install car body brackets
Remove original car body brackets, replave with
our brackets (picture shows the left, the right is
the same).
4.Install tailgate brackets
Remove original tailgate brackets, put a pad on
the back of each bracket, and then restore the
tailgate brackets (picture shows the left, the right
is the same).
5.Install electric struts
Install our left and right struts to the brackets.
drill hole at the circled position, pass the strut
cable through it.
6.Install electric suction lock
Remove the original lock, install our electric
suction lock as shown.
7.Install tailgate button
Drill hole ∮20 at the shown position and install
our provided tailgate button.
8.Apply paint protective film
9.Wiring diagram

1.Height adjustment
Adjust the tailgate to a proper height, long press the tailgate button for 5 seconds, and a long beep indicates that the height is set successfully. 2. 2.Speed adjustment
Tailgate opening and closing speed has 5 gears: default 4th gear, lowest 2ed gear, highest 6th gear. Long press the tailgate button. When you hear the buzzer sound 2 consecutive times, the speed is set in the 2ed gear, 3 consecutive times mean 3rd gear, and so on

**The hot sides must be connected correctly. Otherwise, it will cause over current fusing of the original car fuse. Before installation, be sure to use an electroprobe to determine the power input end. The current flow is shown by the red line in the schematic.

After the installation is completed, the controller needs to be matched when the power is plugged in: the electric tailgate is adjusted to the highest position, and the tail button is pressed for 5 seconds. After a long beep, the button is released, indicating that the matching operation is completed. (If the power off requires a rematch operation).

Note: The installation instructions may differ slightly from the actual operation. If there are any differences, please follow the actual situation or contact us.

purchase link:

Leave a Comment