volvo XC 40 electric tailgate lift install manual

Features

1.Multiple switching methods:Original car remote key/Cab button/tailgate button/ Kick Sensor

2.Intelligent anti-pinch:When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can
stop running to protect the user.

Configuration list

1.control box

2.poles


3.Tailgate button


4.Tailgate button wire


5.Power cable


6.Tailgate lock control wire


7.Electric suction lock wire


8.Cable tie * 20


9.Make hole indication module


10.3M glue*2


11.Longer 3M glue


12.Hole opener(16 mm)


Lay wiring diagram

Lay wiring diagram

Installation process

1.Open the tailgate, remove the big panel
2.Remove the trunk cover, remove the original latch trim panel.
3.Use screwsdriver remove the original air spring strut
4.Use tool remove the ball head.
5.Find the rubber stopper, remove it.
6.Remove the rubber stopper
7.Remove the original lock.
8.Install our new electric lock.
9.Fix the lock motor here.
10.Connect all the related plug into the controller.
11.Remove the original lock plug, connect our lock plug with it.
12.Find the original handle button plug purple and grey wire,
connect our Blue handle button wire with it.
13.Connect our front button yellow signal wire to the driver seat Front tailgate button’s purple and white wire
14.Find the car control box near to the spare tire as shown in red arrow
15.Find the gray plug, there are a CANBUS wire, which are purple with white wire and purple with green wire.
Connect our black CAN-H wire to the purple with white wire, connect our orange CAN-L wire to the original purple with green wire.
16.Front button control tailgate function:
Use this button control tailgate.
17.Make a hole with our tool and install the tailgate button as shown.

Precautions

1.Electric tailgate installation precautions
For safety and to ensure the normal use of the product,
please install it by professional staff.

2.Make sure that there is enough power in the car battery to
ensure that the electric tailgate kit works properly. If the
battery is low, test the electric tailgate after starting the
engine for a while.

3.Before the electric pole is installed, the direction and
position are determined to avoid damage caused by the
reassembly and the circlip is loose. The ball head must be
installed in place to prevent the electric pole from falling.

4.When arranging CAN lines, power lines, button lines, and
control box lines, it is necessary to clearly distinguish the
specific connection methods of these lines to prevent
misconnection.

5.Do not plug or unplug the connected leads while the
power is on to avoid damaging the main unit.

Tailgate activation learning

Raise the tailgate to the highest position, press down about 2cm manually,
long press the newly installed tailgate switch, after hearing the drop,
release your hand, then press the tailgate button, the tailgate is
automatically closed. The setup is complete.
If the door is not closed, you can manually push it gently to close the door

Height setting

Raise the tailgate to your ideal height, press and hold the
newly installed button for about 3 seconds, hear a drop
sound, release your hand, press the tailgate button again,
and the tailgate closes. The height setting is complete

Key/button usage

1.The original car remote control key, long press the
tailgate button to open the tailgate.
2.Click the tailgate button to open or close the tailgate

Purchase link:https://www.hautopart.com/product/volvo-xc40-automatic-tailgate/

Leave a Comment