Volvo XC60 electric tailgate lift install manual

By HansShoW | 12/23/2020 |

The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of one-click control, intelligent anti-pinch, intelligent height adjustment, etc. It can be controlled by the tailgate button on the car key. It is easy to control and practical.

Electric tailgate functions

Easy control:
The electric tailgate can be controlled by the tailgate switch and the vehicle key.

Intelligent anti-pinch:
The tailgate will stop running for protecting the user if obstacles are encountered during its opening or closing.

Configuration list

Control box
Strut*2
Tailgate button
Tailgate button cable
Power cable
Tailgate lock control cable
Electric suction lock cable
Cable tie*20
Make hole indication module
3M tape*2
Longer 3M tape
Hole opener (16 mm)

Installation diagram

Precautions

1. Electric tailgate installation precautions For safety and to ensure the normal use of the product, please install it by professional staff.

2. Make sure that there is enough power in the car battery to ensure that the electric tailgate kit works properly. If the battery is low, test the electric tailgate after starting the engine for a while.

3. Before the electric pole is installed, the direction and position are determined to avoid damage caused by the reassembly and the circlip is loose. The ball head must be installed in place to prevent the electric pole from falling.

4. When laying out the CANBUS wire, power cable, button cable, and control box cable, it is necessary to clearly distinguish the specific connection methods of these cables to prevent misconnection.

5. Do not plug or unplug the connected cables while the power is on to avoid damaging the main unit.

Lay wiring diagram

Install step

1. Original car appearance.
2. Use a flat-blade screwdriver to pry open the
ball retainer clips (do same at right and left).
3. Remove original brackets, replace with our brackets.
4. Install our electric struts (do same at right and left).
5. Pass through the strut cable at the shown position.
6. Remove the screws on the trim panel.
7. Remove the tailgate larger trim panel.
8. Unplug the original lock plug, connect to our
wire connection as shown.
9. Unplug the original tailgate handle switch
plug, connect the gry wire to our blue handle
trigger wire.
10. Wire our provided front button trigger wire to
the front button position, connect to purple-white
wire of the shown original plug
11. Take out the shown trunk trim.
12. Remove the shown screws.
13. Remove the shown screws.
14. Remove the trunk fender trim.
15. Install our provided electric suction lock.
16. Fix the electric suction lock motor with 3M tape.
17. Remove the right side trim panel of trunk, find the
shown CAN plug wrapped with the soundproof cotton.
18. Remove trunk right side trim panel, find the shown green plug, connect our white
decoding wire CAN-H to original car purple-white wire, green CAN-L to original
purple-green wire, red BATTI to power supply, black wire to the ground, then fix the decoder.
19. Connect all the plugs, fix the control box.
20. Install the tailgate button at the shown position.
21. Insert the add-a-fuse to the control box.

Tailgate activation learning

Raise the tailgate to the highest position, press down about 2cm manually, long press the newly installed tailgate switch, after hearing the drop, release your hand, then press the tailgate button, the tailgate is automatically closed. The setup is complete. If the door is not closed, you can manually push it gently to close the door

Height setting :
Raise the tailgate to your ideal height, press and hold the newly installed button for about 3 seconds, hear a drop sound, release your hand, press the tailgate button again, and the tailgate closes. The height setting is complete.

Key/button usage
1. The original car remote control key, long press the tailgate button to open the tailgate.
2. Click the tailgate button to open or close the tailgate

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.

Product link：https://www.hautopart.com/product/2018-volvo-xc60-electric-liftgate/

Posted in Car tailgate & power running board news

Leave a Comment