Skip to content

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

1: original car appearance.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

2: Remove the original tailgate horizontal strip decorative panel

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

3: Remove the two corner decorative panels in turn, and then remove the tailgate large decorative panels.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

4: After the removal effect

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

5: Remove the gas spring of the original car (the same left and right)

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

6: Remove the bracket of the original car and replace the special bracket equipped with our company (the same left and right)

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

7: Replace the ball studs of the original tailgate and assemble the special ball studs of our company.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

8: Installation Our company is equipped with electric struts, with the struts on one end of the motor connected to the body bracket, and the other end connected to the tailgate ball studs (the same on the left and right)

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

9: Remove the rubber plug of the original car and pass through the through hole of the strut. The effect is shown below.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

10: Pull out the original tailgate lock harness and connect it with our wiring harness.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

11: Pull out the harness of the outer door of the tailgate and connect it with the harness of our company.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

12: Remove the small cover on the left side of the tail box to see the GND ground position.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

13: The ground wire in our power cord is connected to this screw and grounded with iron. (Please strictly follow the grounding recommended by our company, otherwise the key switch door is not normal before the key)

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

14: Red: cable, orange: ground, yellow: power cord

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

15: The main wiring diagram is as follows

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

16: Dock all the jacks and fix the control box to the following position

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

17: Remove the original car lock trim and lock wrap (note the dark button on the inside of the car)

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

18: The effect shown after removal is as follows

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

19: Assemble the special lower suction lock assembly equipped with our company

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

20: Place the cable drive position as shown in the figure below.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

21: Install the original tailgate lock trim

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

22: Use the utility knife to remove the interference part of the lock trim panel (digital position in the figure)

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

23: The effect after repair is shown below

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

24: Install the lock trim panel

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

25: Cross the line to the front B-pillar of the vehicle body, and connect to the central control line. The central control signal line needs to be broken.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

26: Our company's line color is yellow, and the original car wiring harness is a two-color line yellow-purple, as shown below.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

27; Disassemble the decorative panel at the bottom left of the driver's seat, as shown below

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

28: Find the body power supply for the common 30A power supply, as shown below

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

29: Connect with the original car OBD

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

30: The front button installation position needs to be punched, and the hole is punched in the upper left corner of the decorative panel (the drill bit is 22mm)

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

31: The effect is as shown in the figure below.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

32: Rear tail button installation position, punched in the left position of the tailgate as shown below (using 22mm drill bit)

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

33: The installation effect is as shown below

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

34: Restore all the decorative panels, the installation is complete, manually close the tailgate reset once, in order to initialize the system.

Wie Power Heckklappe für Mazda CX-5 / CX5 hinzufügen

 

Hinterlassen Sie einen Kommentar





Scroll To Top
WhatsApp Click here to whatsapp us