Discovery Sport electric tailgate lift install manual

By HansShoW | 01/28/2021 |
1. Original car appearance
2. Remove the whole trim
3. Remove the original car lock plug,
Connect it with our harness.
4. Remove original strut
5. Remove the bracket with tool.
(both left and right side)
6. Install the ball head in the
screw hole which near to the
tailgate shaft.
7. Install the power strut.
8. Remove the rubber stopper,
pass our strut wire through the hole.
9. Remove the original latch
10. Install our electric latch.
11. Put the motor here.
12. Remove the trunk left cover,
connect our power fuse to a 20A
constant power adaptor.
13. Connect the GND wire to this
Screw as shown.
14. Power wire’s wiring diagram.
15.Connect related wire with controller,
Fix the controller here.
16. Make a hole with a 22mm
driller to install the tailgate button.

Remarks: After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.
How to use the remote control: Press the key unlock button 3 times within 4s to open or close the tailgate; Cab button: Press to open the tailgate and press it to close the tailgate.

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.

Posted in Car tailgate & power running board news

Leave a Comment