1 Lexus NX200 or NX300 appearance
3 Remove the shackles on both sides of the tailgate
4 Remove the left and right plaques
5 Remove the handlebars on both sides
6 Remove the plaque
7 Use the tool to open the gas spring snap ring, the left and right are the same
8 Remove the original car bracket
9 Install our company with brackets, use screws
10 Install our electric pole (right side of “L” on the left side of “R”)
11 Take out the original car rubber plug
12 Put our pole line into the original hole, the same left and right
13 Strut line trend map, the same left and right
14 Pull out the original car lock plug and connect it with the harness provided by our company.
15 Pull out the original tailgate button plug and connect it with the harness provided by our company.
16 Remove the original car lock trim (note the buckle inside)
17 Remove the original car lock
18 Install the lower suction lock provided by our company.
19 Fix the lower suction motor
20 Power supply negative ground position
21Use the fascia board to open the main driving left side plaque
22 In the re-insurance box, find the common electric power above 20A.
23 Take out the original car OBD.
24 Opposite to our OBD
25 Remove the original reserved hole on the right side of the steering wheel and install the buttons provided by our company.
26 Take out the left lower side trim of the steering wheel
27 Find the black plug
28 Here you need to break the line, connect the A-pillar, our yellow line connects to the original car black line.
29 Wire harness trend diagram
30 the connection control box harness is inserted into the bellows
31 Connect the corresponding harness to the control box and fix the control box
32 Punch the tailgate trim handle box and install the tailgate button (the drill bit is 22mm), pay attention to avoid the iron plate on the tailgate.
33 Restore all the plaques, the installation is complete, manually close the tailgate reset once for system initialization