Pajro Sport electric tailgate lift install manual


The intelligent electric tailgate is suitable for high-end luxury cars. It has the functions of hand-in-one opening, intelligent anti-pinch, intelligent height adjustment, etc. The driver can control tailgate with the car key tailgate button. It is easy to control and practical.

Electric tailgate functions

Easy to open
The electric tailgate can be controlled by the tailgate switch and the vehicle key.
Intelligent anti-pinch When the electric tailgate is opened or closed, obstacles are encountered, and the tailgate can stop running to protect the user.

Disclaimer: The problems and losses caused by improper installation and improper use are not covered by our company’s warranty.

Install steps

1. Original car appearance
2. Remove two side panel.
3. Remove the middle panel.
4. Remove the whole panel.
5. Use a tool to open the gas spring
retaining spring and remove
the gas spring strut.
6. Remove the bracket and use
our screws to mount our bracket
(L left, R right)
7. Remove the two side ball head.
8. Use our 3mm drill make a holes in
the bracket as shown
9. Remove the bracket and continue
to punch with a 9mm driller a hole
10. At the punching position, use a
rivet gun to riveting a rivet.
11. Rivet as shown.
12. Install our new bracket (L
left, R Right)
13. Remove original bracket, use our
screw to install the bracket. (L left, R Right)
14. Install our power strut
(L left, R Right)
15.Use drill (16mm) make hole and
Pass through the strut wire.
16. Remove the original lock,
install our power lock.
17. Plug original lock plug,
connect it with our plug
18. Connect the ground wire to
a screw as shown
19.Remove original lock ring
20. Install our new lock ring
21. Remove the trim as shown in cab.
22.Find a 20A constant power fuse, connect our
power cord to the Fuse adaptor
23.Remove original useless button,
Install our front button.
24. Connect our OBD plug to under
the cab as shown
25. Find the lock signal plug(No.8 plug)
OBD gray wire connect to A port
(second last pin), white wire connect to
B port(last pin), as shown.
26. Wiring diagram: Yellow for
power cord; Blue for OBD.
Orange for front button.
27. Pass the related harness through
corrugated pipe.
28. Connect related wire to
controller box, fixing it as
29. Remove original handle clasp,
install our tailgate button.
30. Before recover all panel.
Power on the system. Please use
your hand close the tailgate at
the first time. Then you can use
the car key to control the tailgate

Remarks: After installing the electric tailgate lift, you must manually close it once and then open it. Finally, the installation is complete.
How to use the remote control: Press the key unlock button 3s to open or close the tailgate; Cab button: Press to open the tailgate and press it to close the tailgate

Product link:

Leave a Comment