Tesla MODEL X Kick Sensor Installation Guide
The dedicated Model X kick sensor for power trunk has been something many people were asking for. It adds one more way to open and close the trunk that makes it that much better. And you yourself can easily install this foot sensor.
1. Remove trunk trims
Open the trunk, follow the steps as shown and remove the trims one by one.

2. Remove side trims
The picture illustrates how to remove trim①②.

3. Remove bottom trims
Take off the trim buckles after removing trim③.

4. Remove side trims
First remove the screws at the marked position, then remove trim ④.

5. Remove side trims
First remove the five screws at the marked position, then remove trim⑤.

6. Remove side trims
The picture after trim⑤ is removed.

7. Remove underbody trim
Take off the two buckles as shown, and remove the trim.

8. Remove underbody trim
Clean the trim inner surface, attach the kick sensor to it with the supplied double-stick tape as shown (Note the “this side up” label).

9. Kick sensor wiring diagram
Lift up the trunk bottom trim, pass the cables out of the car through the holes indicated by the arrow, and connect the sensors.

10. Control box installation position
Attach the control box behind the left trim of the trunk with double-stick tape.

11. Wiring diagram of the Ground (GND)

12. Wiring diagram of the signal cables

13. Way to take electricity (B+)

14. Remove trunk trims

At the end of this manual, if you haven’t bought one, click and buy at Foot sensor for Model X.