VW T5 electric tailgate lift install manual

  • Open and Close the liftgate using a kick sensor.
  • Open and Close the liftgate using the key fob.
  • Close the liftgate with the supplied button (added in the liftgate).
  • Open the liftgate using the front button
    more detail please click here:https://www.hautopart.com/product/vw-t5-t6-power-tailgate/

Configuration list

Control box

Tailgate button
Tailgate button wire
Power cable
Tailgate lock
control wire
Electric suction
lock wire
Cable tie * 20
Make hole indication module
3M glue*2
Longer 3M glue
Hole opener (16 mm)

Precautions 1.Electric tailgate installation precautions For safety and to ensure the normal use of the product, please install it by professional staff. 2.Make sure that there is enough power in the car battery to ensure that the electric tailgate kit works properly. If the battery is low, test the electric tailgate after starting the engine for a while.
3.Before the electric pole is installed, the direction and position are determined to avoid damage caused by the reassembly and the circlip is loose. The ball head must be installed in place to prevent the electric pole from falling.
4.When arranging CAN lines, power lines, button lines, and control box lines, it is necessary to clearly distinguish the specific connection methods of these lines to prevent misconnection.
5.Do not plug or unplug the connected leads while the power is on to avoid damaging the main unit

Installation process

1.Original car
2.Open the rear door
3.Remove the tail door panel
4.Remove two fixing screws from
tail door trim panel
5.Remove the tail door cover
6.Remove the air spring of the original car
7.Remove the original ball and
replace the new ball
8.Drawing after Installation
9.Install electric brace
10.Unplug the original car lock power supply line, cut the milk white line, milk white wire output end connect to our orange open lock signal out wire, and connect the red open lock signal IN wire to the milk white wire input wire. As shown.
11.Unplug the original car lock signal plug and connect the white line on the right show in the figure to our company’s blue lock on position signal wire.
12.Connect the ground wire of the control box to the brown wire of the original car wiper motor plug show in the figure.
13.Fix the control box and connect the wiring harness
14.Connect the power and
signal lines to the front
15.Line the harness from the
waterproof bellows to the body
16.Remove the left decorative panel
and thread the harness to the main seat.
17.Route the power and signal
lines to the main driver
18.Remove the bottom cover of the steering wheel and find the twisted pair harness (CAN H connects the orange black wire of the original car, CAN L connects the orange wire of the original car)

19.As shown in the figure, the signal ground wire is connected to the OBD. (If no this wire in your product, no need to connect.)

20.The power cord runs along the roof of the original car to the bottom of the main driver’s seat.
21.Connect the fuse of the control box power cord to the position shown under the driver’s seat
22.The switch is punched and installed
in this position.

23.Restore parts, installed

Tailgate activation learning
Raise the tailgate to the highest position, press down about 2cm manually, long-press the newly installed tailgate switch, after hearing the drop, release your hand, then press the tailgate button, the tailgate is automatically closed. The setup is complete.
If the door is not closed, you can manually push it gently to close the door.
Height setting
Raise the tailgate to your ideal height, press and hold the newly installed button for about 3 seconds, hear a drop sound, release your hand, press the tailgate button again, and the tailgate closes.
The height setting is complete.
Key/button usage
The original car remote control key, long-press the
tailgate button to open the tailgate.
Click the tailgate button to open or close the tailgate
Disclaimer: The problems and losses caused by improper installation and improper
use are not covered by our company’s warranty.

Leave a Comment